Aspire ET-S Glassomizer
Aspire ET-S Glassomizer
- Top Selling Tank
- Uses Aspire BVC Coils
- Available in the ET-S Starter Kit
The Aspire ET-S is a nice medium sized high quality glassomizer that takes advantage of the awesome capabilities of the Aspire Bottom Vertical 1.6ohm Heating Coils. It holds approximately 3.0ml of e-liquid, but is not as big and bulky as some of the other 3ml+ clearomizer/glassomizers. It has a built in steel mouthpiece, and is a bit longer then some of the other units in the marketplace, but it is the same width as EGO & Spinner batteries. We think it looks slick on these style batteries and is made of high quality Pyrex glass resulting in a very strong & durable glassomizer.
Helpful Tips:
To fill your glassomizer:
- Turn the unit upside down and unscrew the bottom.
- Set the bottom unit aside.
- Run E-liquid along the outside edge of the clearomizer, looking through the window at the side
- Only fill until the e-liquid is just below the center airflow tube.
- Do not get e-liquid into the center airflow tube
- When you are done filling, keep unit upside down and screw base back in.
- Give a gentle blow into your mouthpiece after filling to ensure the airflow tube is clear.
Dry Burning taste?
- Not enough e-liquid – Refill
- E-liquid not getting to heating element – Take several still draws without activating your battery
- (IF APPLICABLE) Your battery voltage is set too high, turn down your battery voltage.
- Your heating coil has worn out. Replace heating coil.
Gurgling / E-liquid getting into airflow hole or into mouth?
- Blow through your mouthpiece until no e-liquid comes out of the small intake holes as the side of your clearomizer
- Ensure that your heating coil is firmly screwed in
- Ensure that the base is screwed in tightly and not threaded properly
- You have overfilled your clearomizer.
- Your heating coil has worn out. Replace heating coil.