Aspire ET-S Glassomizer

Reward Points: 12
In Stock
* Choose Colour:

*
Qty:

Aspire ET-S Glassomizer

 

New Colours Available!

 

NOTE: The Aspire ET-S is now being made with a BVC coil.  Currently, our Black ET-S is the newer model and includes the BVC coil, our Stainless steel will be switching over soon.  The ET-S still works both with the Aspire BDC Coils and the Aspire BVC Coils

 

The Aspire ET-S is a nice medium sized high quality glassomizer that takes advantage of the awesome capabilities of the Davide Dual coil heating coils.  It holds approximately 3.0ml of e-liquid, but is not as big and bulky as some of the other 3ml+ clearomizer/glassomizers.  It has a built in steel mouthpiece, and is a bit longer then some of the other units on the marketplace, but it is the same width as EGO batteries, Spinners, etc. so it looks really slick on these style batteries.  It is made of high quality Pyrex glass and steel, and is a very strong glassomizer.

 

A few little tips:

  • To fill your glassomizer:
    • Turn the unit upside down and unscrew the bottom.
    • Set the bottom unit aside.
    • Run E-liquid along the outside edge of the clearomizer, looking through the window at the side
    • Only fill until the e-liquid is just below the center airflow tube.
    • Do not get e-liquid into the center airflow tube
    • When you are done filling, keep unit upside down and screw base back in.
    • Give a gentle blow into your mouthpiece after filling to ensure the airflow tube is clear.
  • Dry Burning taste?
    • Not enough e-liquid – Refill
    • E-liquid not getting to heating element – Take several still draws without activating your battery
    • (IF APPLICABLE) Your battery voltage is set too high, turn down your battery voltage.
    • Your heating coil has worn out.  Replace heating coil.
  • Gurgling / E-liquid getting into airflow hole or into mouth?
    • Blow through your mouthpiece until no e-liquid comes out of the small intake holes as the side of your clearomizer
    • Ensure that your heating coil is firmly screwed in
    • Ensure that the base is screwed in tightly and not threaded properly
    • You have overfilled your clearomizer. 
    • Your heating coil has worn out.  Replace heating coil.

Write a review

Note: HTML is not translated!
Bad           Good
Live Chat Software